How often should you flush your outboard motor?

A full flushing of the motors must be done after every use, and it’s recommended every six weeks if it’s been sitting in storage. It’s important to run the motors long enough for the thermostat to open, allowing the fresh water to flush the salt from the entire powerhead.

Do I need to flush my outboard after every use?

Most outboard manufacturers recommend a freshwater flush after every use in saltwater to clear the cooling passages of salt residue and scale that can accumulate and impede the flow of vital cooling water through the engine.

What happens if you don’t flush your outboard?

Most boaters know it’s imperative to flush an outboard with freshwater after boating in saltwater or brackish water. Failure to do so can allow corrosion to take hold in your motor’s water passages, compromising your cooling system and shortening the life of your engine.

How often should you flush your boat?

Unless you’re out on a daily basis, yes, you really should flush it after every time you sail. That is a good idea. Now I remember I used to do that with my honda (been 10 years since I had the engine).

IT IS INTERESTING:  Why are car diagnostic tests so expensive?

How long should you flush an outboard motor?

The majority of manufacturers agree that flushing for ten minutes is ideal. You will want to perform the flushing procedure while the outboard is running at idle speed, and the engine is in a vertical position. However, you won’t need to run the engine if you use the flushing port.

How long can you run a boat motor on muffs?

Don’t run the engine unattended. Keep an eye on the muffs and make sure they don’t slip off of the water intakes. Regardless of your task, it’s unlikely that you’ll need to run it more than 10 to 15 minutes.

Are outboards better for salt water?

As well as powering large vessels that require a lot of horsepower to move the boat. Outboard engine boats are better suited for shallow water, salt water, and pontoon boats.

What happens if you start a boat motor out of water?

Without water to cool the engine, it will rapidly overheat inside of the cowling (the cover) and will likely seize up or blow a head gasket as the oil will heat up to a point that it loses its lubricating properties.

Can you leave engine flush in overnight?

Can I leave the engine flush chemical overnight? Engine flush chemicals should not be used for a long period (more than 5-10 minutes). just use it right before an oil change. Longer applications of chemical additives used for engine flush can damage the engine.

How do you use outboard muffs?

Flush muffs are the most common way to flush an outboard; they’re available at most marine stores and online resellers. They’re inexpensive, and easy to use. Connect to a garden hose, fit the muffs over the engine’s water intakes on the sides of the gear case, turn the water on, start the engine, and let it run.

IT IS INTERESTING:  Your question: How do I know if my car battery has a dead cell?

Should you leave your outboard up or down?

You want to leave the engine in the totally trimmed down position. This will allow all of the water to leak out of the engine, midsection, and lower unit. … Making sure that there is not any water in the Lower Unit that could rust gears or freeze and destroy the gear case by flushing the engine with fresh water.

How important is flushing an outboard motor?

Flushing your motors is an essential part of boat maintenance. It clears the saltwater & sand from your motor, helping to prevent salt build-ups and corrosion. … It’s important to run the motors long enough for the thermostat to open, allowing the fresh water to flush the salt from the entire powerhead.

How often should a boat impeller be replaced?

Generally speaking a 5 year interval likely works well for most folks. TomP. Mercury recommends changing the impeller every 300 hours…its in the owners manual. It’s an easy enough job to do yourself if you have some mechanical skills.